Artist Alley T-Shirt Rack Holder

Have you ever wanted to integrate a t-shirt rack into your artist alley display? These pieces were engineered to fit onto the standard cube panels you already use in your setup! 

What's included: 

• x2 3D printed pieces of the printed rack holder
• x1 PVC pipe with an outside diameter of ~22mm. The length of the PVC pipe is cut to 30cm (the standard artist alley width), but if you need it to be cut to 35 cm or a custom size please leave a note in the checkout! 
• x2 of the pipe 'sleeves'. This is a small tube printed out to go over top of the PVC pipe to match your branding and make it look a little nicer!

Notes:

• I strongly recommend using either 2 wire grid panels to go on the sides where the rack sits, or 2 of my 3D printed pegboard panels. These are a lot stronger than a standard panel, and depending on the weight of your t-shirts may be required. The weight is pushed onto the vinyl covering of a standard panel and may cause it to warp over time with enough weight.